Sunday, February 7, 2016

2014 - 2015 Question Papers PAPER III QUALITY ASSURANCE IN NUCLEAR MEDICINE Dr. MGR University

Dr. MGR University  AUGUST 2014 Question Paper
Subject : PAPER III – QUALITY ASSURANCE IN NUCLEAR MEDICINE

[LF 0212] Sub. Code: 2123
B.Sc. NUCLEAR MEDICINE TECHNOLOGY
THIRD YEAR
PAPER III – QUALITY ASSURANCE IN NUCLEAR MEDICINE
Q.P. Code: 802123
Time : Three Hours Maximum : 100 marks
Answer ALL questions
I. Elaborate on: (3 x 10 = 30)
 1. What steps to be followed for Quality standard such as ISO-9001/NABH in
 Nuclear Medicine Dept?
 2. Draw a model Nuclear Medicine Diagnostic department plan and explain in
 respect of its public safety, contamination and in quality control.
 3. Explain the general QA test procedures in scintillation and Gamma detectors.
II. Write notes on: (8 x 5 = 40)
 1. Write the test for spatial resolution of point source in PET scan.
 2. Write the test for Volume response of the system in PET scan.
 3. Write the test for center of rotation (COR) calibration in H-&L- mode in SPECT scan.
 4. Write the test for Intrinsic/Extrinsic uniformity uniformity & sensitivity in SPECT scan
 5. Write the test for Energy Spectrum/Energy Window calibration in
 Scintillation detectors.
 6. Write the test for precision and Linearity for Radiation survey meter.
 7. Write about the Jaszcazk phantom in respect of QA procedures.
 8. Write the test for Photo Peak in SPECT scan.
III. Short Answers on: (10 x 3 = 30)
 1. Contamination Monitor.
 2. Isotope calibrator.
 3. Survey monitor.
 4. Pin source.
 5. Gamma zone monitor.
 6. Thyroid uptake.
 7. Zero adjustment test.
 8. Energy resolution.
 9. Photo peak.
10. Scintillation detector.
*******

Dr. MGR University  AUGUST 2015 Question Paper
Subject : PAPER III – QUALITY ASSURANCE IN NUCLEAR MEDICINE

[LH 0815] Sub. Code: 2123
B.Sc. NUCLEAR MEDICINE TECHNOLOGY
THIRD YEAR
PAPER III – QUALITY ASSURANCE IN NUCLEAR MEDICINE
Q.P. Code: 802123
Time : Three Hours Maximum : 100 marks
Answer ALL questions
I. Elaborate on: (3 x 10 = 30)
 1. Enumerate the acceptance tests during installation of gamma camera.
 2. Describe the routine daily check (quality control of gamma camera, dose calibrator
 and uptake probe).
 3. Define flood check, linearity, uniformity, dead time, resolution for gamma camera.
II. Write notes on: (8 x 5 = 40)
 1. NEMA protocol.
 2. External factors affecting Gamma camera performance.
 3. Spatial linearity.
 4. Field uniformity.
 5. Spatial resolution.
 6. Energy resolution.
 7. Count rate capability.
 8. Sensitivity.
III. Short Answers on: (10 x 3 = 30)
 1. Define quality control in NM.
 2. Test for spatial resolution of point source in PET scan.
 3. Survey meter.
 4. Gamma zone monitor.
 5. Photo peak.
 6. Scintillation detector.
 7. Test for volume response of the system in PET scan.
 8. Energy resolution.
 9. Sino gram.
10. FWHM and pixel size selection in SPECT.
*******
Share This
Previous Post
Next Post

B.E Civil Engineer Graduated from Government College of Engineering Tirunelveli in the year 2016. She has developed this website for the welfare of students community not only for students under Anna University Chennai, but for all universities located in India. That's why her website is named as www.IndianUniversityQuestionPapers.com . If you don't find any study materials that you are looking for, you may intimate her through contact page of this website to know her so that it will be useful for providing them as early as possible. You can also share your own study materials and it can be published in this website after verification and reviewing. Thank you!

0 comments:

Pen down your valuable important comments below

Search Everything Here