Annamalai University december 2014 question paper
B.Sc. DEGREE EXAMINATION December 2014
(COMPUTER AIDED DESIGN)
(SECOND YEAR)
240. ARCHITECTURAL AND ENGINEERING DRAWINGS
Time: Three hours Maximum: 100 marks
SECTION – A
Answer any FIVE questions
(5 × 8 = 40)
1. Write short notes on French curves.
2. List of documents to be submitted for building plan approval.
3. What are the important factors to be considered in planning?
4. Discuss about preparation of line sketch for a single bed room residential
building.
5. Explain the term bulk modules.
6. Differentiate compressible and imcompressible fluid.
7. Explain briefly about the scope of mechanical industry.
8. What are the relationship between voltage, charge and capacitance?
SECTION – B
Answer any THREE questions
(3 × 20 = 60)
9. Explain briefly about
i) FAR and FSI for different buildings and zones
ii) Scanners and plotters.
10. Discuss the following:
i) Minimum size requirements of kitchen and toilet
ii) Planning of residential building.
11. Discuss briefly about mechanical industry related to automobile and CAD
industry.
12. Describe in detail about
i) Fluid properties
ii) Viscosity of fluid.
13. Explain in detail about the concepts of capacitance and temperature coefficient
of resistance.
&&&&&&&
B.Sc. DEGREE EXAMINATION December 2014
(COMPUTER AIDED DESIGN)
(SECOND YEAR)
240. ARCHITECTURAL AND ENGINEERING DRAWINGS
Time: Three hours Maximum: 100 marks
SECTION – A
Answer any FIVE questions
(5 × 8 = 40)
1. Write short notes on French curves.
2. List of documents to be submitted for building plan approval.
3. What are the important factors to be considered in planning?
4. Discuss about preparation of line sketch for a single bed room residential
building.
5. Explain the term bulk modules.
6. Differentiate compressible and imcompressible fluid.
7. Explain briefly about the scope of mechanical industry.
8. What are the relationship between voltage, charge and capacitance?
SECTION – B
Answer any THREE questions
(3 × 20 = 60)
9. Explain briefly about
i) FAR and FSI for different buildings and zones
ii) Scanners and plotters.
10. Discuss the following:
i) Minimum size requirements of kitchen and toilet
ii) Planning of residential building.
11. Discuss briefly about mechanical industry related to automobile and CAD
industry.
12. Describe in detail about
i) Fluid properties
ii) Viscosity of fluid.
13. Explain in detail about the concepts of capacitance and temperature coefficient
of resistance.
&&&&&&&
0 comments:
Pen down your valuable important comments below